COMMERCIAL AND ARCHITECTURAL DOORS
Particleboard Core Door (PC)
Last update : 18 December 2015
Particleboard core (PC) (interior use).
In conformity with industry standards
W.D.M.A. SERIES I.S.1-A-2013
ARCHITECTURAL WOODWORK STANDARDS - ED.2
Fire Rating Details
20 minute neutral or positive pressure.
UL 10C Positive pressure Category A in option
UL 10C Positive pressure Category B
UL 10B Neutral pressure
Refer to fire-rated options of our Architectural Catalog (e-version)
20 minute: 1-3/4 in (44 mm) to 2-1/4 in (57 mm).
Non-rated: 1-3/8 in (35 mm).
Positive pressure: 48 in x 108 in (1219 mm x 2743 mm).
Neutral pressure: 48 in x 120 in (1219 mm x 3048 mm).
Non-rated: 48 in x 120 in (1219 mm x 3048 mm).
ME (Matching Edge): 15/16 in (24 mm) hardwood. Laminated to a piece of 3-3/8 in (86 mm) thick. This piece is made of laminated wood veneer strips of 1/8 in (3 mm) each. These strips are longitudinally laminated by hot pressing (LVL).
Piece of 3-3/8 in (86 mm) thick. This piece is made of laminated wood veneer strips of 1/8 in (3 mm) each. These strips are longitudinally laminated by hot pressing (LVL).
Particleboard core with a density of 28-32 PCF (449-513 kg/m3) LD-1 bonded to the stiles and rails.
Type I (Waterproof); PVA (UF-Free); VOC< 0,683 g/L.
Wood veneer, MDO or HPDL laminated to a HDF.
Lambton Doors' EDGEFENDER: High impact resistant edges.
PE (Plastic Edge); HPDL edges.
Lite and louver opening
Cut-out must not exceed 40% of door area (LD-1). All models: minimum 5 in (127 mm) from stiles or rails. Non-rated: minimum 1-1/2 in (38 mm) from cut-out to cut-out. 20 minute: minimum 2-3/4 in (70 mm) from cut-out to cut-out.
Wood louvers not permitted with 20 minute labeled doors.
Stile and rail dimensions shown are rough sizes, before trimming.
Life of original installation. See our complete warranty for details.
UV Finishing System 9 by AWI. Stain, clearcoat, opaque and primed finish available. Custom color matching available. No VOC. Sealed top and bottom standard. Lambton Doors' ASEPTI: Antimicrobial coated surface in option.